I am trying to play 2 player mode on a few of the games (Donkey Kong Country 2, Ninja Turtles, Mario 3) and whenever I go to put it on 2 player mode using my logitech controllers, both people are controlled by the first controller only? The second one does not work at all? I have them both active and have tested them through my control panel and I also have the RGR plugin v 1.01 but when I go to play 2 player in one of those games like vs mode in mario 3, the primary controller, controls both players at the same time?

Also when I try to adjust the controls through the menu, I can't seam to be able to use my mouse? It stays locked up in the left hand corner of the screen? I type in codes for games but I cannot scroll over and activate them cause my mouse will not move on the menu screen? And I cannot adjust the preset control's for my joysticks in that menu? I use to be able to change the button preset options in the menu with my mouse when I first became a member but now I can't figure out how? I can adjust the "shadow" under the mouse but I can't use the mouse? I have to use the keyboard to get to the controls via the tab button but again cannot find a key on the keyboard (despite pushing virtually every key) that will let me change the buttons on my controllers?

I have tried to mess around with being able to control the "GUI" via the controller option, but there is no option to be able to use the mouse like it use to be for me? I also tried using "untrap mouse" option in the "GUI" and that did nothing either?

It would be great if someone could assist me in being able to resolve these issues as I am so bummed that I cannot use the 2 player mode on my computer through VIZZED any longer, and also resolve that little issue with the mouse not being able to be used in the menu section.

Thanks so much for you time!!

- MC

For the mouse problem, see this page and check if it helps - https://www.vizzed.com/vizzedboard/thread.php?id=26396. If that helps, then the second controller might be recognized if you manually configure the controls for Input Device #1 and #2. Other than that, try the controllers on separate USB hubs or different ports (front, back, etc.).

I've heard that the Logitec profiler might have something to do with this, but I don't know how reliable the advice is. Or maybe Xpadder will help.